Compressor Basics: Which one is the better Option |
Здравствуйте, гость ( Вход | Регистрация )
Here You Can Support Our Work and .:LavTeaM:. Services |
Compressor Basics: Which one is the better Option |
29.09.2017 - 02:53
Сообщение
#1
|
|
Активный пользователь Группа: Пользователи Пользователь №: 188190 Сообщений: 863 Регистрация: 11.01.2017 Из: Pakistan Загружено: байт Скачано: байт Коэффициент: --- Спасибо сказали: 409 раз(а) |
Dear Chemical & Mechanical Engineers
Which option is the better way to install the Hot gas Bypass in a Centrifugal Compressor System Option A: Route the hot gas bypass from compressor discharge ->> Suction Scrubber Option B: Route the hot gas bypass from compressor discharge ->> directly to compressor suction
Прикрепленные файлы
|
|
|
19.10.2017 - 17:32
Сообщение
#2
|
|
Прохожий Группа: Пользователи Пользователь №: 141788 Сообщений: 41 Регистрация: 9.01.2011 Загружено: байт Скачано: байт Коэффициент: --- Спасибо сказали: 20 раз(а) |
Hi, I assume it's too late for your question, but I just read it.
Anyway, I suppose the better option is to short-recyle because of the high diameter lines involved. However, there's an impact in the high temperature achievable at the suction, so you should analyze it and now the limits for your system (it depends on the compression ratio). Good luck! Sebastián |
|
|
Текстовая версия | Сейчас: 23.04.2024 - 09:46 |